Rubee fully automatic honey extractor with very powerful 180w motor.
For 4 honey frames Zander, German normal and Dadant brood chamber (285 mm high).
For 8 half frames Dadant with a height of 145 mm The honey extractor with new punched special base.
This base is stamped in one piece and therefore has no joint in the lower part.
In addition, the bottom slopes towards the outlet.
The honey therefore flows out of the honey extractor automatically without tilting.
The cutting crane is located at the lowest point of the ground.
The honey extractor also has 2 handles for carrying the catapult.
In addition, the pendulum is equipped with a smooth-running and powerful 180 watt motor.
The stainless steel housing control system includes 7 programs with 7 cycles each. Some programs are pre-programmed, but these can be reprogrammed at any time as desired.
Honey extractor
Ton ø inside: 78 cm
Barrel ø outside: 79.5 cm
Honeycomb size: 29.20 cm x 43.00 cm x 5 cm
Total height adjustable: 133.00 cm or up to 110.00 cm
Spout adjustable in height: 40.00 cm or 45.00 cm
Motor power: 180 Watt Siemens motor with fully automatic control + safety device on the lid Boiler, basket, axle + crossbar, all made of stainless steel!
Weight: 65 kg
ATTENTION: The controller and lid opening are shown facing forward for illustration. Because the honeycombs are easier to load into the centrifugal basket, we supply the control system and lid opening at the back.
Frame dimensions: - 420 x 220 mm
- 327 x 459 mm
- 420 x 159 mm
- 420 x 110 mm
- 420 x 285 mm
- 370 x 223 mm
- 448 x 232 mm
- 450 x 285 mm
- 450 x 145 mm
- 435 x 159 mm
- 338 x 200 mm
- 370 x 260 mm
- 250 x 330 mm
- 340 x 260 mm
- 260 x 410 mm
- 330 x 250 mm
